User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
433D Systems, Inc.
Shell Options
A
Top Surface Layers
Increase the value for a thicker top
surface layer.
B
Bottom Surface Layers
Increase the value for a thicker
bottom surface layer.
C
Outer Walls
Increase the value for increased
strength of the outer walls.
C
B
A
Support Borders
Support borders (A) reinforce supports (B) for overhanging parts and
should not be used for holes and cavities (C).
Draw Fine Features
Select enable for small parts with ne features. For larger parts needing more accuracy, this feature should not be enabled.
A
B
C