User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
463D Systems, Inc.
PREPARING AND PRINTING A CREATION
WARNING: THE PRINT JETS BECOME EXTREMELY HOT DURING SETUP AND OPERATION. DO NOT TOUCH THE
PRINT JETS.
CAUTION: Do not change the material cartridge color or material type during printing. Doing so may damage the
printer.
The CubePro software client includes useful tools to place a creation in the optimum position for printing. The model can be moved or
rotated using the mouse.
Pan/Zoom: Rotate the mouse wheel in either direction
Rotate the Print Pad: Left-click and drag the mouse to change the view of the model
Move the Print Pad: Right-click and drag the mouse to move the print pad.
1. Select Open Model.
NOTE: Select Open Model Assembly if there are multiple parts in
the model.
2. Browse to the creation le and select Open.
NOTE: The creation or assembly will appear on the print pad.
NOTE: You can open multiple creations on the same print pad.
NOTE: To open .cubepro les, select Open from the Print File
menu, browse to the creation le and select Open.
3. If your creation requires a single color, select the Single Color checkbox from
the Home tab.