User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
483D Systems, Inc.
NOTE: The build le may take a few minutes to create. During this
time, the le is being converted from a .stl le to a .cubepro le.
NOTE: Once the build is complete, the estimated print time will
appear. Select OK to close the window.
NOTE: Once the le has been built, it must be sent to the printer. There are two ways to send the le:
• Wireless
• USB Mass Storage Device
NOTE: Larger les will take longer to send to the printer using a wireless connection. Transferring larger les with
a USB mass storage device is strongly recommended.
11. To save to a USB mass storage device, select Save. Browse to the connected
mass storage device and select Save. If sending wirelessly, go to step 13.
NOTE: The le must be stored in the root directory of the USB mass
storage device.
12. Insert the USB mass storage device into the printer’s USB inlet port. Proceed to
step 14.
13. To send the le to the printer using the wireless utility, select Send.
14. Select PRINT on the printer touchscreen display.
NOTE: Refer to the section titled Printing Your Creation for more
information.