User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
493D Systems, Inc.
10
OPERATION PROCEDURES
APPLYING CUBE GLUE
Cube Glue contains water-soluble glue that adheres the part to the print pad. It is important that glue is applied to the print pad before
starting any print to ensure that the creation does not move during the printing process.
The glue contains a foam applicator under the cap. It is recommended that the bottle is turned upside-down with the cap on to allow the
glue to settle into the applicator before applying.
For best results, apply two thin layers of glue to the print pad using slow circular motions when prompted by the touchscreen display.
Apply the glue in a pattern that is slightly larger than the footprint of the creation you are printing.
Layer 1
Apply a thin layer of glue to the print pad:
Layer 2
Apply a second thin layer of glue to the print pad in the opposite direction:
NOTE: For best results, allow the glue to dry before printing.