User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
553D Systems, Inc.
6. Conrm your choice by selecting the checkmark.
NOTE: The Select WIFI Connection Type screen will display the ad
hoc status as well as the IP address of the printer.
7. In Windows®, select Start > Control Panel.
8. Type network in the search box.
9. Select Network and Sharing Center.
10. Select Set up a new connection or network.
11. Select Set up a wireless ad hoc (computer-to-computer) network.
12. Select Next.
13. Follow the steps in the wizard.