User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
563D Systems, Inc.
11
CUBEPRO MAINTENANCE
RESTORING ROUGHNESS TO THE PRINT PAD
If the print pad is too smooth, the print material and glue may not adhere properly. Using the sandpaper included in the toolkit, wipe
the print pad diagonally across the print pad from corner to corner in both directions. Rinse and thoroughly dry the print pad before
installing it into the printer.
CLEANING THE JET WIPER
In addition to being a scraper for the print jets, the jet wiper assembly is also a refuse bin, collecting print material that has been primed
from the print jets. As the jet wiper lls, it will need to be emptied regularly.
1. With the print pad lowered, lift up the jet wiper off the thumbscrew rest.
2. Pull the jet wiper up and out to separate the mounting posts from the keyhole
slots.
3. Remove the jet wiper assembly from the printer.
4. Remove the waste material from the jet wiper and then reinstall it in the CubePro. Refer to the section titled Printer Setup for
more information about installing the jet wiper. Recycling information can be found in the section titled Cubify Sustainability
Program.