User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
573D Systems, Inc.
GENERAL CLEANING
Waste material from the printing process can accumulate inside the printer. Using a slightly damp, lint-free cloth, wipe the interior of the
CubePro including the print plate, the print pad, cartridge bays and anywhere else you might nd pieces of plastic waste material.
RISK OF SHOCK: DO NOT WIPE DOWN ANY ELECTRICAL COMPONENTS. ALWAYS KEEP AWAY FROM ALL
AREAS WHERE ELECTRONIC COMPONENTS ARE INSTALLED.
ADJUSTING THE JET WIPER ASSEMBLY
The jet wiper is designed to scrape the print jet tip, removing any waste material remaining after extrusion.
1. Remove the lid from the top of the printer.
2. Ensure the print pad is at its lowest position.
3. Power off the printer and disconnect it from utility power.
4. Holding the extruder assembly, gently position it over the jet wiper assembly.
5. Verify the wiper blade meets the tapered portion (A) of the print jet tip. If it does,
the jet wiper is properly adjusted. Proceed to step 8.
NOTE: If the wiper tip is too high, proceed to the next step. If the
wiper tip is too low, proceed to step 7.
A
View From Top