User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
583D Systems, Inc.
6. If the wiper blade is too high, remove the jet wiper assembly and turn the
adjustment thumbscrew (A) clockwise. Reinstall the jet wiper and return to step
5.
7. If the wiper tip is too low, remove the jet wiper assembly and turn the
adjustment thumbscrew (A) counter-clockwise. Reinstall the jet wiper and return
to step 5.
8. Once satised with the adjustment, you may connect your printer to utility power
and power on the printer.
A
A