User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
623D Systems, Inc.
Printing the Level Gap Calibration File
NOTE: Ensure the print pad is completely clean from glue and printed parts before beginning this procedure.
1. Navigate to http://cubify.com/en/CubePro/Activate. Select CALIBRATION
FILES and extract them to your computer’s hard drive.
2. Navigate to the le location and copy the appropriate le to your USB mass
storage device.
3. Insert the USB mass storage device into the USB host port on the printer.
4. Select PRINT.
5. Using the arrows, navigate to the Level Gap Calibration le and select PRINT.
NOTE: There are two Level Gap Calibration les as well as four
Nozzle Offset Calibration les. The two Level Gap Calibration les
are print material specic. Select the le based on the material
cartridge type installed in cartridge bay 1.
6. Apply two thin layers of Cube Glue to the print pad in an area of 50 mm x 50
mm. Select the checkmark to continue.
NOTE: For more information, refer to the section titled Applying
Cube Glue.
NOTE: It may take several minutes to print the le.
7. When nished, remove the print pad and verify the Level Gap.
NOTE: Refer to the sections titled Reading The Z-Gap Calibration
Print and Reading The Print Pad Level Calibration Print.
NOTE: If any adjustments are needed, perform this procedure
again after making the adjustments. Make sure all glue and plastic
residues have been removed prior to performing this procedure
again.