User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
653D Systems, Inc.
Incorrect Closed Z-Gap
If there is a gap (B) between the Closed Z-Gap bars and the baseline (A),
turn all three print pad adjustment knobs counter-clockwise (left) 1-step and
then print the le again to verify the lines touch. If the lines do not touch on
the second print, adjust the knobs again 1-step and reprint the le. Continue
to do this until the lines meet.
Correct Open Z-Gap
If there is a gap (B) between the Open Z-Gap bars (C) and the baseline (A)
and there is no gap between the Closed Z-Gap bars and the baseline, the
Z-Gap is correct.
Incorrect Open Z-Gap
If there is no gap (B) between the Open Z-Gap bars (C) and the baseline
(A), turn all three (3) print pad adjustment knobs clockwise (right) 1-step
and print the le again to verify that the lines do not touch. If they touch on
the second print, adjust all three (3) print pad adjustment knobs clockwise
(right) 1-step and reprint the le. Continue this procedure until there is a
gap.
A
B
B
B
B
A C
C
B
B
A