User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
733D Systems, Inc.
MOVING THE PRINT JETS
The Print Plate Calibration menu provides a way to manually move the print jets and the print pad. The MOVE JETS utility can be
useful to test the X, Y and Z motors to ensure they are working properly.
1. To move the print jets or the print pad, select MOVE JETS.
NOTE: The X: up arrow moves the print jets to the right and the X:
down arrow moves the print jets to the left.
NOTE: The Y: up arrow moves the print jets to the back of the printer
and the Y: down arrow moves the print jets to the front of the printer.
NOTE: The Z: up arrow raises the print pad and the Z: down arrow
lowers the print pad.
2. Move the print jets or print pad in the desired direction and select the checkmark
when nished.