User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
743D Systems, Inc.
UPDATING THE CUBEPRO FIRMWARE
The CubePro rmware can either be updated via wireless connection or by using a USB mass storage device. When using a USB
mass storage device to update the rmware, log into your www.cubify.com account and download the latest rmware to your device.
Updating Firmware Using USB
1. Select SETUP.
2. Navigate to the Advanced screen and select FIRMWARE.
3. Select USB KEY.
4. Insert the USB mass storage device into the USB port and select the
checkmark.