User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
773D Systems, Inc.
NOTE: The printer will begin downloading new rmware. The blue
bar is also a progress indicator.
NOTE: The download could take a few minutes.
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER
FROM UTILITY POWER DURING THE UPDATE PROCESS.
NOTE: If no new rmware is available, select the checkmark to
continue.
NOTE: If the rmware download fails, select RETRY to start the
download again. Select CANCEL if you do not want to update the
rmware.
NOTE: The rmware will begin to install. The blue bar is also a
progress indicator.
NOTE: This process could take a few minutes.
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER
FROM UTILITY POWER DURING THE UPDATE PROCESS.
4. Press and release the touchscreen display ON/OFF button and the display will
restart.