User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
783D Systems, Inc.
REPLACING FUSES
The printer has two (2) fuses that are designed to provide moderate circuit protection. If the fuses become defective, refer to the
following procedure to replace the fuses.
Caution: Double Pole/Neutral Fusing.
1. Power off the printer and disconnect the power cord from the printer.
2. Open the fuse door above the main power switch.
3. Remove the fuse cartridge from the power inlet housing.
4. Remove the defective fuses and install new ones.
Caution: Ensure the replacement fuses are rated correctly.
NOTE: Fuse: 5x20mm T10A L 250V.
5. Insert the fuse cartridge into the power inlet housing.