User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
793D Systems, Inc.
6. Close the fuse door.
7. Connect the printer power cord and power on the printer.
LUBRICATING THE BEARING RODS
After every 100 hours of operation, the bearing rods should be lubricated.
Caution: Do not spray lubricant directly on the bearing rods. Applying too much lubricant can leave residue
throughout the printer. The bearings only require a thin layer of grease to operate properly.
1. Power off and disconnect the printer from utility power.
2. Apply a small amount of bearing rod grease (Part Number:
403194-00) to a clean, lint-free cloth.
3. Using the cloth, wipe the six (6) bearing rods (1-6).
NOTE: Ensure each bearing rod has been fully
treated with a thin layer of bearing rod grease.
4. Manually move the print jet carriage (A) front-to-back and left-
to-right.
NOTE: The print jet carriage should glide smoothly.
Back
Front
1
2
5
3
4
6
A