User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
53D Systems, Inc.
4
AT A GLANCE
Get acquainted with your CubePro 3D printer before you begin printing. This section identies the important areas that will be discussed
throughout this guide.
CubePro Trio is depicted for illustration purposes only. Locations of important areas are the same for the CubePro and CubePro Duo.
A
Removable Top Cover
B
Touchscreen Display
C
Touchscreen On/Off Button
D
Fuses
E
Printer Power Switch
F
Power Inlet Port
G
USB Inlet Port
H
Printer USB Port
A B C
D
E
G
H
A
Print Jet 1
B
Print Jet 2
C
Print Jet 3
D
Jet Wiper Assembly
E
Material Cartridge 1
F
Print Chamber Heater
G
Print Plate
H
Print Pad
I
Material Cartridge 2
J
Material Cartridge 3
A
B
C
D
E
G H
I J
F
F