Safety data sheet

Safety Data Sheet
according to Regulation (EC) No 1907/2006 (REACH),
GHS Rev 04 (2011): US, OSHA, CMA, ANSI
WHS Regulations Australia,
JIS Z 7253 (2012): Japan
CubePro
®
Nylon filament
Revision Date: 30 October 2014
________________________________________________________________________________________
SDS GHS • Cube Nylon • 403219-S12-00-A • ENGLISH 1
1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING
1.1 Identification of the substance or preparation: Nylon filament
1.2 Use of the substance / preparation: For use with the CubePro
®
3D Printer
1.3 Company/undertaking identification:
3D Systems, Inc.
333 Three D Systems Circle
Rock Hill, South Carolina U.S.A.
Phone: [phone] or
Toll-free Phone: [phone]
e-mail: [e-mail]
800.424.9300 - Chemtrec
3D Systems Europe Ltd.
Mark House, Mark Road
Hemel Hempstead
Herts HP2 7 United Kingdom
Phone: [phone]
e-mail: [e-mail]
703.527.3887 - Chemtrec (U.S.)
___________________________________________________________________________________
2. HAZARDS IDENTIFICATION
2.1 Classification: Not classified according to GHS, Regulation (EC) No. 1272/2008, HazCom 2012.
2.2 Label Elements
Regulation (EC) No, 1272/2008:
Hazard pictograms and signal word: None
Hazard statements: None
0
0
0
NFPA Ratings
0 = Minimal
1 = Slight
2 = Moderate
3 = Serious
4 = Severe
Hazardous Materials Identification System (HMIS):
(Degree of hazard: 0 = low, 4 = extreme);
Health 0
Flammability 0
Physical Hazards 0
__________________________________________________________________________________________
3. COMPOSITION/INFORMATION ON INGREDIENTS
3.1 Preparation related information
Description: Polyamide
__________________________________________________________________________________________
4. FIRST AID MEASURES
4.1 In case of inhalation: Fumes released from overheated material may cause respiratory irritation. In case of
inhaling dense smoke, move affected person to fresh air. If respiratory irritation occurs or breathing becomes difficult
seek medical attention immediately.
4.2 In case of skin contact: If molten material gets on skin, cool rapidly with cold water. Do not attempt to peel
material from skin. Use mineral oil to loosen the material. Seek medical attention for burns.
4.3 In case of eye contact: Flush eyes with plenty of water for at least 15 minutes. Get medical attention if symptoms
persist.
4.4 In case of ingestion: Ingestion is unlikely. If ingested, drink plenty of water and seek immediate medical
attention. Do not induce vomiting.
____________________________________________________________________________