Owner manual

Setup
3Dlabs Graphics Accelerator Card User's Guide
14
Installing your Wildcat II 5110 Windows 2000 driver
1. After installing your Wildcat II 5110 Graphics Accelerator Card, start up Windows 2000 and log
on using an account with administrative privileges. The Hardware Wizard appears.
2. Click Next on the Found New Hardware Wizard.
3. Under Install Hardware Device Drivers, click “Search for a suitable driver for my device
(recommended),” then click Next.
4. Under Locate Driver Files, make sure the appropriate search location is selected, and that Disk 1
of the driver media is in the appropriate drive; then, click Next. The Wizard locates the driver
installation files.
5. Under Driver Files Search Results, click Next to start the installation.
6. Insert Disk 2 when prompted, then click OK to continue with the installation.
7. Once the driver successfully installs, click Finish to dismiss the Found New Hardware Wizard.
Important: Windows 2000 recognizes the dual pipelines as two devices. The Found New
Hardware Wizard will display a second time to finish the installation.
You must repeat Steps 3 – 7 above to complete the installation.
8. When told that the workstation must be restarted for the new settings to take effect, remove
the delivery media from the disk drive (if applicable) and click Yes to restart the
workstation.
eÉáÇá=aêáîÉêë=Ñçê=^ìíçaÉëâ=^ééäáÅ~íáçåë
eÉáÇá=aêáîÉêë=Ñçê=^ìíçaÉëâ=^ééäáÅ~íáçåëeÉáÇá=aêáîÉêë=Ñçê=^ìíçaÉëâ=^ééäáÅ~íáçåë
eÉáÇá=aêáîÉêë=Ñçê=^ìíçaÉëâ=^ééäáÅ~íáçåë=
==
=
The Wildcat II 5110 Heidi
®
device driver allows full screen multisampling of and compatibility with
AutoDesk applications as well as hardware acceleration of the Wildcat II 5110 through the use of
OpenGL. To install the Heidi driver and to activate full screen multisampling, consult the
README.TXT
located on disk 3 of the Wildcat II 5110 delivery media.
sÉêáÑó=íÜÉ=aÉÑ~ìäí=sáÇÉç=aáëéä~ó=aêáîÉê=
sÉêáÑó=íÜÉ=aÉÑ~ìäí=sáÇÉç=aáëéä~ó=aêáîÉê=sÉêáÑó=íÜÉ=aÉÑ~ìäí=sáÇÉç=aáëéä~ó=aêáîÉê=
sÉêáÑó=íÜÉ=aÉÑ~ìäí=sáÇÉç=aáëéä~ó=aêáîÉê==
==
=
This section describes how to verify the correct display driver is loaded on your workstation.
Verifying the default video display driver in Windows NT
1. From the operating system Start menu, go to Settings/Control Panel/Display, and click the
Settings tab on the Display Properties dialog box.
2. Click Display Type, then verify that Wildcat II 5110 is listed under Display. This indicates
that the appropriate driver is installed.
3. Click Cancel to close the Display Properties dialog box.