Owner manual

Software Configuration

3Dlabs Graphics Accelerator Card User's Guide

3. On the Wildcat Monitor Display Properties dialog box, click Configure Monitor to change

the display mode, select a monitor type, and change the resolution/refresh rate. Once you

have made the changes you require, click OK to accept the new configuration and dismiss

the Configure Monitor dialog box. You are returned to the Wildcat Monitor Display

Properties dialog box.

4. In Windows 2000, click OK on the Display Properties dialog box to accept the changes. In

Windows NT, you must return to the Settings page, then click OK to accept the changes.

5. Reboot the workstation if you are prompted to do so. Most changes will take effect without

rebooting.

Note: See Appendix A, Specifications, for a list of available monitor resolutions.

See Enabling Stereo Display in this chapter for instructions on changing the Display Mode.

See Enabling the Dual Monitor Feature under Windows 2000 in this chapter for instructions on

configuring dual displays.