3DLABS WILDCAT REALIZM INSTALLATION GUIDE WILDCAT REALIZM 800 WILDCAT REALIZM 500 WILDCAT REALIZM 200 WILDCAT REALIZM 100 85-000057-001 (Rev 85G-000057-001 (RevB) A)
©Copyright 2005 by 3Dlabs – A Creative Company 3Dlabs and Wildcat are registered trademarks, and Realizm, SuperScene, and DirectBurst are trademarks of 3Dlabs. Pentium is a registered trademark of Intel. OpenGL is a registered trademark of SGI. AutoCAD is a registered trademark of AutoDesk Inc. Microsoft, Direct X, Windows 2000, and Windows XP are registered trademarks of the Microsoft Corporation. Athlon, Opteron, and 3DNow! are registered trademarks of AMD.
IN STA L LAT ION GU IDE Installing your Wildcat Realizm Graphics Accelerator Card Refer to your computer’s documentation for instructions on opening and closing the computer, identifying the AGP 8x or PCI Express expansion slots, and adding expansion cards. The User’s Guide referred to in this documentation is included on the Wildcat Realizm Product CD and is also available from the 3Dlabs website at http://www.3dlabs.com/support/.
Connecting power to the Wildcat Realizm 800 The Wildcat Realizm 800 (which conforms to the PCI Express™ x16 Graphics 150W-ATX Specification 1.0 for graphics accelerators) uses power from the system power supply via a High-End power connector specifically designed to plug directly into a x16 PCI Express graphics card. If your system power supply does not have the High-End power connector, it does not conform to the PCI Express High-End power specification.
Connecting a DVI monitor 1. Make sure the power to the computer is turned off. 2. See the documentation that came with your monitor for information on the type of connection that is required. Your monitor cable will have either a Digital Video Interface (DVI)-I connector or a 15-pin VGA connector depending on monitor type. If your monitor is a VGA monitor see “Connecting a VGA monitor” below. 3.
