User Manual

51
6.4.2 Cable Cam Operation
Before running a Cable Cam shot, always ensure that the entire path is
free of potential obstructions.
Figure 6.4.2.1: App - Cable Cam Controls
After you tap B to finish recording waypoints, the App switches to a screen that resembles the preceding illustration.
The timeline near the bottom of the video image shows the number of waypoints and the relative distances between
them, as well as the total amount of time it takes to fly the prerecorded route.
To control Cable Cam through the App, tap the right arrow at the bottom center of the screen to fly Solo through the
sequence of waypoints in the order you recorded them, and the left arrow to fly through the waypoints in reverse
order. When either of these is active, the arrow changes to a Pause symbol (||), which you can tap to make Solo stop
and hover temporarily. Cable Cam’s default cruise speed is set to 9 mph (4 m/s).
To operate Cable Cam using the Controller, move the right stick to the left to fly towards the start of the waypoint
sequence and to the right to fly towards the endpoint. To pause at the current location, release the right stick.
To look left and right, enable Free Look (see Cable Cam Settings, following) and use the left stick. This overrides the
recorded camera angles temporarily. To stop Solo at any time, press Pause. To exit to standard flight, press Fly.
Figure 6.4.2.2: Controller - Cab
Camera Cable
le Cam Controls