User Manual

52
6.4.3 Cable Cam Settings
To access the settings from the in-flight Cable Cam interface, select Options with the three dots at the bottom-left of
the main screen.
Figure 6.4.3.1: App - Cable Cam Settings with Time Lapse off
The settings consist of the following:
• Free Look: When on, you can adjust the direction in which the camera points with the controller left stick.
When off, the camera points in the recorded direction.
• Time Lapse: When on, greatly increases the maximum Time Of Cable setting. Using a higher Time setting
lets Cable Cam fly Solo much slower than you can manually, easily capturing slow-motion video.
• Time of Cable: This slider lets you change Solo’s speed along the Cable Cam path by adjusting the total
time it takes to travel the route. By default, it gives you a time range that slightly decreases the default time
at the left end of the scale (thus traveling faster) and slightly increases it at the right end (thus traveling
slower).
To change the speed, tap anywhere along the slider length or drag the small green time indicator. The “Time
of Cable” readout shows the current amount of time Solo takes to travel the full length of the shot, based on
the slider setting.
When Time Lapse is on, the maximum value for Time Of Cable increases greatly. For details, see Time
Lapse (preceding).
Figure 6.4.3.2: App - Cable Cam Settings with Time Lapse on
6.4.4 Saving Cable Cam Shots and Using Saved Shots
When you set up a Cable Cam shot in the Solo App, the app automatically saves the shot, including the general
location and waypoints. The Saved Shots feature in the App lets you retrieve the shot at any time subsequently to
repeat the Cable Cam shot exactly as you initially set it up.
When you tap the Shot List button on the main screen of the Solo App, the following screen appears: