User Manual

54
6.4.5 Deleting Saved Cable Cam Sequences
Figure 6.4.5.1: App - Selecting Saved Shots for Deletion
The Select feature allows you to delete multiple saved shots, as follows (refer to preceding illustrations): Tap Select,
then tap the thumbnails for all the shots you want to delete. As you do so, a check-mark icon (3) appears on each
selected thumbnail, and a message at the top of the screen (1) indicates the number of shots selected.
Once you’ve selected one or more saved shots, delete them by tapping the trash-can icon (2) at the top right, or tap
Cancel to exit the deletion procedure.
6.4.6 Running a Saved Cable Cam Sequence
Each thumbnail shows a satellite image of the environment of the saved shot plus the path of the shot, with
waypoints. To use a saved shot, tap its thumbnail. This takes you to a full-screen overhead view of the saved shot,
plus several controls. If Solo’s current location isn’t quite close enough to where the Cable Cam shot was saved, the
screen resembles this:
Figure 6.4.6.1: App - Prompt to Correct Solo Position
The green arrow (1) shows Solo’s location and heading, the yellow line (2) indicates the path of the saved Cable
Cam waypoint sequence, the small blue dot (3) represents the path’s starting point, and the blue circle (4) shows the
area within which Solo must be located before you can run the saved shot.