User's Manual

3e–527A3 Wireless Access Point – 8 Port Chapter 3: Access Point Conguration
29000152-001 B 15
Chapter 3: Access Point Conguration
Introduction
The 3e–527A3 comes with the capability to be congured as an ac-
cess point. As it incorporates two separate 802.11 wireless cards, one for
conguring a local WLAN and one for use in bridging, it can also be
congured for bridging, either with access point or gateway conguration
on the WLAN side. Conguration as a gateway is discussed in Chapter 4
and conguration for bridging is discussed in Chapter 5.
Preliminary Conguration Steps
For preliminary installation the 3e–527A3 network administrator may
need the following information:
• IP address – a list of IP addresses available on the organization's
LAN that are available to be used for assignment to the AP(s)
• Subnet Mask for the LAN
• Default IP address of the 3e–527A3
• DNS IP address
• SSID – an ID number/letter string that you want to use in the con-
guration process to identify all members of the wireless LAN.
• The MAC addresses of all the wireless cards that will be used to
access the 3e–527A3 network of access points (if MAC address
ltering is to be enabled)
• The appropriate encryption key for Static 3DES or Static AES if
state-of-the art key management will be used.