User's Manual

3e–527A3 Wireless Access Point – 8 Port Chapter 3: Access Point Conguration
34 29000152-001 B
3e–527A3 Wireless Access Point – 8 Port Chapter 3: Access Point Conguration
29000152-001 B 35
Rogue AP Detection
The Wireless Access Point — Rogue AP Detection screen allows the
network administrator to set up rogue AP detection. Enable rogue AP
detection and enter the MAC Address of each AP in the network that you
want the AP being congured to accept as a trusted AP. (You may add
up to 128 MAC addresses.) Enter an email address for notication of any
rogue or non-trusted APs. (The MAC Address for the 3e–527A3 is located
on the System Conguration — General screen. You can also select the
following lter options.
• SSID FIlter: Check the SSID option to only send rogue APs that
match the AP's SSID or wireless bridge's SSID.
• Channel Filter: Check the channel lter option to only send rogue
APs that match the AP's channel or the wireless bridge's channel.
• If both options are checked, only APs that match both the SSID
and channel are sent.
The Adjacent AP list, under Monitoring/Reports on the navigation
menu, will detail any marauding APs.