User's Manual
3e–527A3 Wireless Access Point – 8 Port Chapter 5: Wireless Bridge Conguration
84 29000152-001 B
3e–527A3 Wireless Access Point – 8 Port Chapter 5: Wireless Bridge Conguration
29000152-001 B 85
Manual Bridging
When the wireless bridge is in manual bridging mode, you can manu-
ally select a signal strength LED MAC and enable or disable spanning
tree protocol. You can also delete remote AP's MAC addresses.
MANUAL BRIDGING GENERAL SETTINGS OPTIONS
Bridging
Mode
Manual Bridging manual bridging selected
Signal
Strength LED
MAC
Not Assigned Allows you to set the number of one of
the Remote APs which will be listed at
the bottom of the screen once the system
is operational This wireless bridge be-
comes the guiding port that is displayed
in the WLANNSS LED on the front of
the 3e–527A3 as a signal.
Spanning Tree
Protocol (STP)
Enable/Disable Enable STP is there is any possiblity that
a bridging loop could occur. If you are
certain that there is no possibility that
a bridging loop will occur, then disalbe
STP. The bridge will be more efcient
(faster) without it. If you are not sure,
the safest solution is to enable STP.