User Manual
3e-528 Wireless Video Server Chapter 2: Hardware Installation
12 29000142-001 A
3e-528 Wireless Video Server Chapter 2: Hardware Installation
29000142-001 A 13
To comply with FCC RF exposure compliance requirements, the
antennas used with the 528 must be installed with a minimum
separation distance of 20 cm from all persons, and must not be co-
located or operated in conjunction with any other antenna or transmitter.
Installation should be accomplished using the authorized cables and/or
connectors provided with the device or available from the manufacturer/
distributor for use with this device. Changes or modications not ex-
pressly approved by the manufacturer or party responsible for this FCC
compliance could void the user’s authority to operate the equipment.
Installation Instructions
The 3e-528 is intended to be installed as part of a complete wireless
design solution. The 3e-528 has a operating temperature range of 0-40ºC
and should be installed in an area with shade or out of direct sunlight.
This manual deals only and specically with a single 3e-528 device as
a unit. The purpose of this chapter is to describe the device and its iden-
tiable parts so that the user is sufciently familiar to interact with the
physical unit. Preliminary setup information provided below is intended
for information and instruction for the wireless LAN system administra-
tion personnel.
It is intended that the user not open the unit. Any maintenance
required is limited to the external enclosure surface, cable connec-
tions, and to the management software (as described in chapter
three through ve) only. A failed unit should be returned to the manufac-
turer for maintenance (refer to Chapter 7 for technical support).
Minimum System and Component Requirements
The 3e-528 is designed to be attached to the wall at appropriate loca-
tions. To complete the conguration, you should have at least the follow-
ing components:
• PCs with one of the following operating systems installed: Win-
dows NT 4.0, Windows 2000 or Windows XP;
• A Wi-Fi compatible 802.11b/g device for each computer that you
wish to wirelessly connect to your wireless network. (For wire-
less cards, and particularly if you will be using secure FIPS mode
with AES, we recommend that you select the 3e-110 PC Card with
3e-010F Crypto Client software (sold separately) or install the 3e-
010F software with any compatible PC Card. (If you will be using
WEP, the 3e-010F software is not required);
• Access to at least one laptop or PC with an Ethernet card and
cable that can be used to complete the initial conguration of the
unit.
• A Web browser program (such as Microsoft Internet Explorer 5.5
or later, or Netscape 6.2 or later) installed on the PC or laptop you
will be using to congure the Access Point.
• TCP/IP Protocol (usually comes installed on any Windows PC.)