User Manual
3e-528 Wireless Video Server Chapter 5: Bridge Conguration
68 29000142-001 A
3e-528 Wireless Video Server Chapter 5: Bridge Conguration
29000142-001 A 69
Navigate to the Wireless Conguration — Bridging screen.
In the rst section: General, you will see the MAC Address of the
bridging card. This is used as the BSSID on Bridge 2.
Wireless Mode is 802.11b/g Mixed. Set the Tx Rate to AUTO. Chan-
nel Number must be set the same for each bridge to communicate. TX
Pwr Mode can be left on Auto unless the power needs to be regulated.
Set Spanning Tree Protocol to Enable unless you are sure that there is no
chance of a loop.
Bridge signal strength LED port allows you to set the number of one
of the Remote APs which will be listed in section 3 at the bottom of the
screen once the system is operational. Click Apply to accept your changes
but remain on that screen.
In the second section on the Wireless Conguration — Bridging screen,
add the BSSID of the remote bridge. The BSSID corresponds to that
bridge’s MAC address. Data entry is not case sensitive. You may also
enter a note that denes the location of the remote bridge. Then click Add
to accept. The remote bridge’s BSSID will now appear in the third section
of the page. If, at some time you wish to delete the entry, simply click the
check box next to it and conrm by clicking Delete.
Next, navigate to Wireless Conguration — Bridging Encryption.
Select the appropriate key type and length and the key value. The encryp-
tion key value and type for Bridge 1 must be the same as for Bridge 2. For
wireless bridging, only AES and 3DES are available for encryption.