User's Guide

3e-531AP Wireless Access Point

Chapter 4 Gateway Con guration

29000125-001 C

Using the navigation bar to the left, navigate to the

System Con gu-

ration — Operating Mode

page, select the

Gateway Mode

radio button,

and click

Apply

. The 3e-531AP will reboot in gateway mode and reset all

prior settings to factory default state.

You can then proceed to change the management screens as necessary

to recon gure the device as a gateway. Con guration in gateway mode

allows you to set  rewall parameters. This is the main difference between

the screens you will see in gateway mode and those covered in access

point setup as discussed in Chapter 3.

Note that you can't deploy the 3e-531AP as a bridge in Gateway

mode, nor is it FIPS 140-2 compliant.

The following sections cover the functions and screens in gateway

mode. Much of the infomation is similar to the access point mode but is

presented here for your convenience.