RP01 User manual Copyright © 2019 3Egreen Inc.
Update Record Update 2019.06.29 Stark Song Copyright © 2019 3Egreen Inc.
Outline Update Record ................................................................................................................ I Outline............................................................................................................................. i 1.System Architect ...................................................................................................... 1 2.Installation .....................................................................................................
1.System Architect RP01 receives the data from the measurer then passes throught the data into GW08 which is a sub-1G to WIFI gateway . 2.Installation ․Pre condition: setup one GW08-00 and make sure is work fine with WIFI AP.
3.LED Status Description There ae two LEDs to indicate the RP01 status : ․Normal mode : The two LEDs will be still flashed every second ․Right LED (Sub-1G Status): The LED flash indication shows Sub-1G behavior working normally. ․Left LED(BLE Status): The LED flash indication shows BLE behavior working normally.
Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.