Quick Guide
18
2.10 Run the headband cable in the rubber band groove and close the rubber band as shown in gure 2.10-a by clipping the rubber
band ridges in gure 2.10-b.
Push cable in
rubber groove
(2.10-a) (2.10-b)
Clip/Close rubber ridges
2.11 Continue to clip all ridges (gure 2.11-a), while making sure the cable is bedded in the plastic groove shown in gure 2.11-b.
Make sure all the ridges are clipped, the cable is fully bedded in the groove, and cable loops are made on both sides of the headband
to allow stress relief as seen in gure 2.11-c.
(2.11-a) (2.11-b)
EN