Quick Guide

20
2.13 Pressing on the headband as shown in gure 2.13-a, pull the wire loop of the headband from under the rubber piece, then
run the rubber piece under the wire loop (gure 2.13-b). This may require some pushing force and caution to prevent rubber jacket
damage. Repeat for both sides of the headband until complete (gures 2.13-c and 2.13-d).
(2.13-a) (2.13-b)(2.13-b)
Right loop
(2.13-c)
Left loop
(2.13-d)
2.14 Inspect the headband converted headset to make sure that everything has been assembled properly. The headband cable
should be looped in between the headband guides as shown in gure 2.14-a. You should be able to read the PELTOR letters when
the headset is placed as in gure 2.14-b. If the converted headset doesn’t look as shown in gures 2.14-a and 2.14-b, retrace
your steps and redo the assembly. The Headband to Helmet Attachment section gives detailed instructions on how to remove the
headband guides which you may need to do to correct the assembly of this section.
(2.14-a) (2.14-b)
EN