User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Ordering Information
- Reader Specifications – FCC Part 15, Industry Canada RSS 21
- Reader Specifications – FCC Part 90, Industry Canada RSS 13
- Reader Specifications – ETSI (ID4100-001-ETSI and -002-ETSI)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- Internal Antenna Specifications (FCC)
- Internal Antenna Specifications (ETSI)
- Battery Specifications (Optional)
- External Antenna Specifications (FCC)
- External Antenna Specifications (ETSI)
- Bulkhead Connector/Interface Cable Pinout
- Safety and Regulatory Information
Appendix A
Using the Wiegand Interface
96
IDentity 4100 User Guide
A.7.
Using RCT to Configure the Wiegand Interface Module
You can use the embedded Reader Configuration Tool to configure the WIM
parameters. Perform the following:
Open RST
1 From your Windows desktop, select:
Start→Programs→Sirit→IDentity4100→Reader Startup Tool (RST)
2 Select a specific reader and press
Configure
.
3 The Reader Configuration Tool (RCT) is displayed.