User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Ordering Information
- Reader Specifications – FCC Part 15, Industry Canada RSS 21
- Reader Specifications – FCC Part 90, Industry Canada RSS 13
- Reader Specifications – ETSI (ID4100-001-ETSI and -002-ETSI)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- Internal Antenna Specifications (FCC)
- Internal Antenna Specifications (ETSI)
- Battery Specifications (Optional)
- External Antenna Specifications (FCC)
- External Antenna Specifications (ETSI)
- Bulkhead Connector/Interface Cable Pinout
- Safety and Regulatory Information
1
2 3 4 5 6 7 8 9
Reader Overview
IDentity 4100 User Guide
1
Reader Overview
Reader Hardware
The IDentity 4100 is a multi-protocol, multi-regional Radio Frequency
Identification (RFID) System that operates in the 860 – 960 MHz UHF band.
The IDentity 4100 is an integrated high performance, multi-protocol, multi-
regional Radio Frequency Identification (RFID) Reader System that operates
in the 860 - 960 MHz UHF band. The reader is configured at the factory to
operate within a specific regulatory region (for example: FCC in the 902-928
MHz ISM band or ETSI 865-870 MHz).
Figure 1
IDentity 4100 UHF Reader with Universal Mount
As shown in the following figure, the IDentity 4100 reader contains one
integrated antenna and supports one additional Tx/Rx antenna. The reader
is equipped with both RS-232 serial and Ethernet interfaces.
Figure 2
IDentity 4100 Power and I/O Connections (FCC reader shown)