User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Ordering Information
- Reader Specifications – FCC Part 15, Industry Canada RSS 21
- Reader Specifications – FCC Part 90, Industry Canada RSS 13
- Reader Specifications – ETSI (ID4100-001-ETSI and -002-ETSI)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- Internal Antenna Specifications (FCC)
- Internal Antenna Specifications (ETSI)
- Battery Specifications (Optional)
- External Antenna Specifications (FCC)
- External Antenna Specifications (ETSI)
- Bulkhead Connector/Interface Cable Pinout
- Safety and Regulatory Information
Appendix B
AVI Lane Mapper
116
IDentity 4100 User Guide
Automatic Monitoring Session
The Automatic Monitoring Session the application waits a specified length
of time to setup the next grid square before beginning the polling interval.
This length of time is defined on the
Options
dialog. A sound is played at
the end of each polling interval.
When an Automatic Monitoring Session starts, the first available grid in the
square is highlighted yellow. The application obtains the current reader
configuration before the first polling interval starts. A progress bar is
displayed while the application is waiting to start the first polling interval.
When the waiting period has expired, the polling interval starts. A progress
bar is displayed whenever a polling interval is currently running.
The same results are displayed as the Prompt Monitoring Session and a
sound is played at the end of the polling interval before the next waiting
period begins.
User Select Monitoring Session
During this monitoring session, the user is prompted with a dialog at the
start of the session and in between each polling interval. This method
allows the you to select the next grid square to be polled and for an
unlimited time to setup the next grid square. This method can be used for
taking sampling data from just specific squares in the grid. You must press
OK
on the dialog before the next polling interval begins.
When a User Select Monitoring Session starts, the reader’s configuration is
retrieved from the reader. A dialog is displayed prompting you to select the
next grid to be polled.