User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Ordering Information
- Reader Specifications – FCC Part 15, Industry Canada RSS 21
- Reader Specifications – FCC Part 90, Industry Canada RSS 13
- Reader Specifications – ETSI (ID4100-001-ETSI and -002-ETSI)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- Internal Antenna Specifications (FCC)
- Internal Antenna Specifications (ETSI)
- Battery Specifications (Optional)
- External Antenna Specifications (FCC)
- External Antenna Specifications (ETSI)
- Bulkhead Connector/Interface Cable Pinout
- Safety and Regulatory Information
Appendix B
AVI Lane Mapper
120
IDentity 4100 User Guide
Stop a Monitoring Session
1 To stop a monitoring session at any time, select:
Actions
→
Stop Monitoring Session
2 Or, to stop a Prompt or User Select Monitoring session, press the
Cancel
button on the message box or dialog displayed between polling
intervals.
Restart Monitoring Session
1 To restart a stopped monitoring session or start a session that was
loaded from a file, select:
Actions
→
Restart Monitoring Session
2 The following dialog is displayed:
This dialog is the same as shown when starting a new monitoring
session, except only the Location, Description, and Physical Grid
Square Size maybe edited.
If the session does not have the reader’s configuration information, the
utility will retrieve it from the reader before restarting the monitoring
session.