User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Ordering Information
- Reader Specifications – FCC Part 15, Industry Canada RSS 21
- Reader Specifications – FCC Part 90, Industry Canada RSS 13
- Reader Specifications – ETSI (ID4100-001-ETSI and -002-ETSI)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- Internal Antenna Specifications (FCC)
- Internal Antenna Specifications (ETSI)
- Battery Specifications (Optional)
- External Antenna Specifications (FCC)
- External Antenna Specifications (ETSI)
- Bulkhead Connector/Interface Cable Pinout
- Safety and Regulatory Information
1
2
3 4 5 6 7 8 9
Reader Equipment Installation
8
IDentity 4100 User Guide
Connecting the Power
The IDentity 4100 operates on 24 VDC provided through the bulkhead
connector on the rear of the reader. Connect the power supply to the reader
and connect the power supply to your 100–240 VAC, 50-60 Hz power
source. Allow 30 seconds for the reader to initialize.
Refer to the Chapter 8 – Specifications for details on the bulkhead
connector.
Two power cables rated for usage at 24V are available for the IDentity
4100:
h
PN S3114-019 – IDMaX-ID5100 20' Cable with RJ-45 Connector
h
PN S3114-011 – IDMAX-ID5100 7' Cable with RJ-45 Connector
Caution:
The Sirit supplied power/data cable is only to be used with the Sirit 24 VDC power
supply. Use of these cables with power supplies providing lesser voltages may
result in cable and/or reader damage.