User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Ordering Information
- Reader Specifications – FCC Part 15, Industry Canada RSS 21
- Reader Specifications – FCC Part 90, Industry Canada RSS 13
- Reader Specifications – ETSI (ID4100-001-ETSI and -002-ETSI)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- Internal Antenna Specifications (FCC)
- Internal Antenna Specifications (ETSI)
- Battery Specifications (Optional)
- External Antenna Specifications (FCC)
- External Antenna Specifications (ETSI)
- Bulkhead Connector/Interface Cable Pinout
- Safety and Regulatory Information
1 2 3 4
5
6 7 8 9
Reader Startup Tool
IDentity 4100 User Guide
23
Customize Discovery Options
You can customize the reader discovery options including the Listen
Address and Request Multicast Address.
h Listen Address – Address that RMT uses to listen for UDP discovery
packets from the reader. With Version 2.0 this is customizable on the
reader.
h Request Multicast Address –Address used by RMT to send out the UDP
update request packets. With 2.0 this is now customizable on the
reader.
In addition, you can select if you want a secure connection for the Test,
Configure, and Diagnostic Tools. This connection uses the HTTPS protocol
and any data transferred between devices is encrypted.
1 On the RST tool bar select
Options
from the
Discovery
pull-down
menu.
2 Select either
IP version 4
or
IP version 6
.
3 Enter the
Listen Address
and
Request Multicast Address
as required.
4 Select whether you require a secure connection for the Test, Configure,
and Diagnostic Tools.
5 Press
Apply
.