User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Ordering Information
- Reader Specifications – FCC Part 15, Industry Canada RSS 21
- Reader Specifications – FCC Part 90, Industry Canada RSS 13
- Reader Specifications – ETSI (ID4100-001-ETSI and -002-ETSI)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- Internal Antenna Specifications (FCC)
- Internal Antenna Specifications (ETSI)
- Battery Specifications (Optional)
- External Antenna Specifications (FCC)
- External Antenna Specifications (ETSI)
- Bulkhead Connector/Interface Cable Pinout
- Safety and Regulatory Information
1 2 3 4 5
6
7 8 9
Reader Configuration Tool
50
IDentity 4100 User Guide
Setup Antenna/Cables
This page allows you to configure the properties of the reader’s antenna
configuration. For detailed description of each of the antenna and cable
variables, refer to Antenna Configuration in Chapter 4 – Reader Behavior of
the IDentity 4100 Protocol Reference Guide.
Enter the appropriate values for each antenna parameter and press the
Submit
button to update the antenna and cable configuration.
Antenna Setup
The reader is
configured at the
factory to operate
with specific
antennas.
Antenna Gain
Antenna gain may
differ, depending
on the specific
regulatory region.