User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Specifications (FCC)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- External Antenna Specifications (FCC)
- Bulkhead Connector/Interface Cable Pinout
- Battery Specifications (Optional)
- Safety Instructions
- Disposal of the IDentity 5200 Reader
- Reader Maintenance
1
2 3 4 5 6 7 8 9
Reader Overview
IDentity 5200 User Guide
1
Reader Overview
Reader Hardware
The IDentity 5200 is a multi-protocol, multi-regional Radio Frequency
Identification (RFID) System that operates in the 860 – 960 MHz UHF band.
The reader is configured at the factory to operate within a specific
regulatory region (for example: FCC Part 90).
Figure 1
IDentity 5200 UHF Reader
As shown in the following figure, the IDentity 5200 reader supports two
Tx/Rx antennas. The reader is equipped with both RS-232 serial and
Ethernet interfaces.
Figure 2
IDentity 5200 Power and I/O Connections