a [iva @ a Ge Sie en fe 98-6 ogre Wb gti 513 Gandhian Port Configuration The Gandhian port is a simplex type communication compliant to the SIA 26-bit standard as well as extended formats. u pe ime Transmission on the Gandhian interface can only occur when a corresponding Host Upload Event has been configured and satisfied. As Version 1.
before, the pulse width is the time that a data pulse js active for valid data and the pulse Interval Is the time between those pulses. Index is the offset {in bits) within the translated tag data where the serialization Information will begin, Length specifies the Length of the data packet, not including any protocol overhead, Both Parity and Checksum protocols are supported in addition to raw data format.
paramour DEER ME responsiveness 6.3 Parameter Summary Each of the following parameters may be configured using the Get and/or Set Parameter commands. Field Name Attribute, Type Description Notes Firmware,Name R sting Name of firmware. Ex) “Integrated Zip Reader” Firmware Majorette R i Malory referee version. Firmware Minerva R iH Minor release version. le. updates Firmware Bulldozer R i4 Internal development version. System. Time RW 1508601 Current reader date time, Read Trigger.
True = Index backup is up-to-date, False = Index hes not been “Transfusion Index Stored R clean | stored, 8 Esn Nomenclature, RW siting Manufacturing Nomenclatures, ex)integratedZip” 4 Esn. Boarder RW. String, Manufacturing Board Version, oxJ2.2.3" 4 Esn. Serial RW String Manufacturing Serial Number. 4 Egn Test Date RW String Manufacturing Test Date, Format: 4 Esn.
Response; responsiveness “paramour “paragon paramour paramour
<{member> somersetting 1002200330044 slurring whatshisname > Response: irresponsibility “paramour paramour
Response: responsiveness paramour paragon “name <4 revivalism “para paramecia responsiveness 6.9 Store Translation Table index This method will commit the RAM based translation table indexes to FLASH memory. If an up-to-date index table has already been transferred to FLASH memory, it will not be re-written. Coming: StoreTranslationindex methodicalness Response; responsiveness paramour paramour
Appendix A Default Values for Configuration Parameters Parameter Default Value Range Date and Time US Central (GMT-6) GP Active state Low Pulse width 100 ms GPO Active state Low Drive type Push pull Pulse width 25 ms 1-899 ms Pulse period 50 ms 1-999 ms Pulse repeat 0 Serial Port Port enable Enabled Protocol None Signal type Baud rate 115200 9600 115200 Parity None Start bit 1 Stop bit 1 1-2 Data bits 8 5-8 Hold off 20 ms 0-080 ms Gandhian Port Hold off 10 ms 0.
Control enable Disabled Default Translation 1D Handler ID 0 0-8 Dealer handler ID 0 0-8 Dealer code Not used Facility code Not used Gate Control Gate type Normal Input None GP -GP Output Gene GOOD ~ GPO Trigger Settings Trigger enable Enabled Trigger input TO GP ~ GP Trigger output None GOOP ~ GPO Trigger duration 100 ms Re trigger Enabled Filter Duplicate Filter Enable Enabled Fitter timeout 2 Sec 1-255 sec Validation count 1 1-256 Validation attempts a 1-255 Pass back Disabled Ethernet Enabled Enabled CPD
Appendix B Interface Cable Pin out Am phenol connector pin out (rear face of socket insert shown) Am phenol Connector Ethernet Category & Conner tor Yeti General Purpose Outputs General Purpose Inputs RE-232 Gandhian Serial DE-8 2 Power Connector site set ~N Circles Indicate twisted pairs Interface cable and connector pin assignments Version 1.