User's Manual

December 6, 2006 Proprietary Information 19
Revision 1.0
4.4.1 SYSTEM Sub-Commands
The SYSTEM command utilizes sub-commands and
parameters in the following manner:
Table 6 System Sub-Commands
Note: when coming out of STANDBY and returning to the
ENABLED state, allow 200ms before sending commands to
the IDentity MaX Mobile reader.
Sub-
Command
Code
Type
Command
Description
Return
Status
Message
NO_CHG 0x00 Mode
No change (the system mode is not
changed)
Yes
STANDBY 0x01 Mode
This is a system mode command:
STANDBY (0x01) - Processor ON, all
RF circuitry OFF
Yes
ENABLED 0x02 Mode
Processor, receiver circuitry, and PLL
ON, TX OFF
Yes
RF_ON 0x80 Test Turn ON the RF transmitter Yes