User's Manual

Appendix B
Disposal of the INfinity 610 Reader
INfinity 610 User’s Guide
97
7 Remove the two (2) retaining nut/screws on each side of the serial
connector.
8 Left out the main circuit board and turn over.
9 Locate the battery on the upper right quadrant of the board.
10 Use a small flat-blade screwdriver to push the battery out of the holder.
11 Properly dispose of battery according to local and regional laws and
regulations.
12 Replace the main circuit board and install the base on the reader.
13 Using a Torx (T15) screwdriver, Install the six (6) torx screws to secure
the reader base to the reader enclosure.
14 Properly dispose of reader according to local and regional laws and
regulations.
Battery