User's Manual

Preface
INfinity 610 User’s Guide i
Preface
Intended audience
This document is intended for those who wish to setup and operate the
INfinity 610 Radio Frequency Identification system. Before attempting to
install, configure, and operate this product, you should be familiar with the
following:
h Windows-based software installation and operation
h Device communication parameters including Ethernet and serial
communications
h RFID reader configuration including antenna placement
h Basic digital input/output control
What’s in this guide
The information in this guide is presented as follows:
Chapter 1 - Reader Overview:This chapter provides a brief overview of the INfinity
610 hardware and software.
Chapter 2 - Reader Equipment Installation – This chapter describes how to
mechanically and electrically install the reader.
Chapter 3 - Reader Startup Tool (RST) Software Installation – This chapter
describes how to install the Microsoft Windows RST application.
Chapter 4 - Reader Operation – This chapter describes how to initially test a reader
and how to operate deployed readers.
Chapter 5 - Reader Startup Tool (RST) – This chapter describes the RST and the
various functions you can perform with this Microsoft Windows application.
Chapter 6 - Reader Configuration Tool (RCT) – This chapter describes the RCT and
the various functions you can perform with this embedded reader application.
Chapter 7 - Configuring Digital Inputs and Outputs – This chapter describes how to
setup the reader’s digital inputs and outputs.
Chapter 8 - Specifications – This chapter detailed mechanical, electrical, and
environmental specifications for the INfinity 610.
Chapter 9 - Safety Instructions – This chapter provides important safety information
about the INfinity 610. All users must read this section before installing or
operating this reader.
Appendix A - IN610 Digital Input/Output Interface Module – This appendix provides
information for installing, configuring, and using the external digital interface
module.
Appendix B - USB Port Setup – This appendix includes USB port driver installation
and setup procedures for both Windows XP and Windows 7.
Appendix C - Disposal of the INfinity 610 Reader – This appendix provides
instruction for removing the battery and disposing of the reader.