User Manual

IDentity Flex Hardware Manual - Notices sirit

Version 2.3 Page ii

Notices

NoticesNotices

Notices

Sirit Inc., 33 City Centre Drive, Suite 250, Mississauga, Ontario, Canada, L5B 2N5

Information contained within this manual is subject to change without notice. No part of this manual may be reproduced or

transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose

Trademarks: Product names mentioned in this manual may be trademarks, and they are used for identification only.

Part Number: IDFLEX–MAN-Version 2.3

Release Date: 20 January, 2005

SITE LICENCE – CUSTOMER DISCLAIMER

Customer (end user) acknowledges that a site license is required for each IDentity Flex system location. It is the

customer’s responsibility to file for the site license and submit the appropriate filing payment. SIRIT can assist with the

completion of the forms. United States filings require completion and submission of FCC Form 601 main with schedule D

and H. Canadian filings require completion and submission of Industry Canada Forms IC2365BB and IC2430BB.

WARNING – ON-BOARD BATTERY

NOTICE

For PLUGGABLE EQUIPMENT, the socket/outlet shall be installed near the equipment and shall be

easily accessible. For PERMANENTLY CONNECTED EQUIPMENT, a readily accessible disconnect

device shall be incorporated into the fixed wiring.

NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment to an outlet or circuit different to that which the receiver is connected.

 Consult SIRIT.

RF Exposure Warning

To comply with the FCC radiofrequency (RF) Exposure requirements, the antenna(s) used with this

device must be installed to provide a minimum separation distance of 1 meter from all persons.

NOTICE

Note: This equipment complies with FCC Part 90 and Industry Canada RSS-137 rules. Any changes

or modifications not expressly approved by SIRIT could void the user’s authority to operate the

equipment. To maintain compliance, the IDentity Flex reader must be used with the power supply that

was supplied with the reader.

TRANSPONDER NOTICE

WARNING! Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type recommended by the manufacturer. Dispose of used batteries according to the

manufacturer’s instructions.