User Manual

IDentity Flex Hardware Manual – Installation sirit
Version 2.3 Page 30
Figure 3.7 – RG-58U Amphenol 82-5375 Installation (Part A)
ANTENNA CONNECTOR ASSEMBLY - RG-58/U CABLE
AMPHENOL CRIMP/SOLDER-TYPE CONNECTOR NO. 82-5375
A = .531" (13.5 mm)
A
B
C
B = 0.233" (5.9 mm)
C = 0.140" (3.5 mm)
STEP 1.
LAY OUT THE CONNECTOR PARTS FOR IDENTIFICATION. FROM LEFT TO RIGHT - CRIMP FERRULE, CENTER PIN
AND THE CONNECTOR BARREL.
STEP 2.
STRIP CABLE JACKET, BRAID AND DIELECTRIC TO DIMENSIONS SHOWN. CUT SHARP AND SQUARE. DO NOT
NICK BRAID, DIELECTRIC OR CENTER CONDUCTOR. SLIDE CRIMP FERRULE ONTO CABLE AS SHOWN - DO NOT
COMB OUT BRAID.
STEP 3.
SLIGHTLY FLARE END OF CABLE BRAID AS SHOWN TO FACILITATE LATER INSERTION OF
INNER FERRULE. PLACE CONTACT PIN ON CABLE CENTER CONDUCTOR BUTTING AGAINST
DIELECTRIC. CENTER CONDUCTOR SHOULD BE VISIBLE THROUGH INSPECTION HOLE
SOLDER
CONTACT PIN
OUTER CRIMP FERRULE
INNER FERRULE
MAIN BODY
STEP 4.
TIN CENTER CONDUCTOR BEFORE INSERTION INTO CONTACT
PIN. SOLDER CONTACT PIN TO CENTER CONDUCTOR BY
FEEDING SOLDER INTO INSPECTION HOLE AS SHOWN. DO NOT
LEAVE SOLDER ON OUTSIDE OF PIN - SCRAPE OFF WITH KNIFE.
AVOID EXCESSIVE HEAT - 5 SECONDS MAXIMUM TO PREVENT
SWELLING OF DIELECTRIC WHICH WILL NOT FIT THRU BARREL IF
ENLARGED.
STEP 5.
INNER FERRULE
CAREFULLY INSERT CONTACT PIN INTO CONNECTOR BARREL SO INNER
FERRULE SLIDES UNDER CABLE BRAID. PUSH CONNECTOR BARREL FORWARD
UNTIL CONTACT PIN SNAPS INTO PLACE IN INSULATOR.
CENTER CONDUCTOR
VINYL JACKET
BRAID WIRE
DIELECTRIC INSULATION
RG-58/U
CABLE
DWG-IDFLEX-ANT-CABLE-01A
INSPECTION HOLE
OUTER CRIMP FERRULE