Product Brochure

Making your job a whole lot easier.

Construction and Home

Improvement Markets Division

3M Center, Building 223-4S-02

St. Paul, MN 55144-1000

1 800 494-3552

www.3M.com

Minimum 10%

Post-Consumer Fiber

3M, Scotch-Blue, the plaid

design and the BlUE color of

the tape are trademarks of 3M.

Scotch is a registered

trademark of 3M.

70-0710-7831-8

An easy way to mask trim

The Scotch-Blue

™

painter’s tape

applicator puts easier masking in the

palm of your hand. This innovative tool

is designed to quickly and precisely

apply tape flush against the wall.

Painters of all skill levels are able to

mask trim and woodwork quickly, to

achieve professional painting results.

This time saving applicator is pre-

loaded with the versatile Scotch-Blue

painter’s tape for multi-surfaces. The

medium-adhesion tape allows it to be

left on a surface for up to 14 days and

still remove cleanly.

• Properly clean and dry surfaces before

masking. This can help prevent

paint seepage.

• For the best results, start in the corners

of a room and work outward.

• To secure any loose ends, press a putty

knife or 5-in-1 tool over the tape surface.

PAGE 1
An easy way to mask trim The Scotch-Blue™ painter’s tape applicator puts easier masking in the palm of your hand. This innovative tool is designed to quickly and precisely apply tape flush against the wall. Painters of all skill levels are able to mask trim and woodwork quickly, to achieve professional painting results. This time saving applicator is preloaded with the versatile Scotch-Blue painter’s tape for multi-surfaces.
PAGE 2
How to use Easy to refill The compact design of the applicator makes it easy to control. It can be used in either direction, right or left-handed. Follow the steps below to ensure accurate use of the applicator and professional paint lines. Look for the applicator refill rolls of Scotch-Blue painter’s tape next to the applicator in most paint departments. The applicator is easy to refill; follow the instructions below. 1. The applicator is designed to be held on the outer edges of tool.