Datasheet
Product Information
Mini Clamp Wiremount Plug Connector
3M Deutschland GmbH Tel.: 02131 / 14 2040 3 - 6 February 2004
Electronic Solutions Fax.: 02131 / 14 2065
Carl-Schurz-Straße 1 E-Mail: 3minterconnects.de
41453 Neuss
Example 2) At the time of combination with UL1007, AWG24 (11/0.16), finish contour f 1.49, Heat-
resistant vinyl isolation outer bark electric wire made in Showa Electric Wire & Cable Co.,Ltd. and
37104-3163-000 FL made in 3M
An average of 46.6 N (the fewest 35.9N).
Example 3) At the time of combination with IR-1, 0.14SQ (7/0.16), finish contour f 1.34, Cure PE
isolation outer bark electric wire made in Showa Electric Wire & Cable Co.,Ltd. and 37104-3163-000
FL made in 3M
An average of 23.0N (the fewest 18.8N).
Quality Performance
Unit Characteristics
TEST
DESCRIPTION
REQUIREMENT TEST CONDITION RELATED STD.
Reference
Dielectric with-
standing voltage
No appearance of arcing
and break down.
Leak current : 1mA MAX
Impressed voltage is AC 1000V rms between
two adjacent contacts for 1 minutes.
MIL-202F-301
Insulation
Resistance
1000MMIN
Impressed voltage is DC500V between two
adjacent contacts for 1minutes.
MIL-202F-302
Mating characteristic
It depends on combination with the Mini-Clamp connector series 372XX & 37304 series
TEST
DESCRIPTION
REQUIREMENT TEST CONDITION RELATED STD.
Reference
Insertion &
Withdrawal Force
(Initial)
Insertion2N/pin
MAX.
Withdrawal0.5N/pin
MIN.
Tensile speed : 5mm/min. Spec. value is
estimated by one contact pin.
Retention Force of
Latch
58.8N MIN. Tensile speed: 25mm/min.
Vibration Electrical properties
shall be stable after
test. Discontinuity
1sec. Max.
Tested during vibration test together (See
table 1)
MIL-202F-201
A
Shock Electrical properties
shall be stable after
test. Discontinuity
1sec. Max.
50G , 11 m sec , 3 cycles, 3 directions
(X,Y,Z)
MIL-202F-213
B
Electrical Specifications
TEST
DESCRIPTION
REQUIREMENT TEST CONDITION RELATED STD.
Reference
Electrical
Continuity
Electrical properties shall
be state under test.
Discontinuity 1sec
MAX.
Tested during Vibration test together Refer TABLE-2
Contact Resistance The initial readings are in
milli-ohms. 20mMAX.
The low-signal level contact resistance shall be
tested with circuit current of 1mA and open
circuit voltage of 20 mV maximum. The
termination resistance includes bulk resistance
of contact, and resistance of solder joints of
connectors to circuit boards.