Datasheet

Product Information
Mini Clamp Wiremount Socket Connector
3M Deutschland GmbH Tel.: 02131 / 14 2040 3 - 8 February 2004
Electronic Solutions Fax.: 02131 / 14 2065
Carl-Schurz-Straße 1 E-Mail: 3minterconnects.de
41453 Neuss
Example 2) At the time of combination with UL1007, AWG24 (11/0.16), finish contour f 1.49, Heat-resistant
vinyl isolation outer bark electric wire made in Showa Electric Wire & Cable Co.,Ltd. and 37104-3163-000
FL made in 3M
An average of 46.6 N (the fewest 35.9N).
Example 3) At the time of combination with IR-1, 0.14SQ (7/0.16), finish contour f 1.34, Cure PE isolation
outer bark electric wire made in Showa Electric Wire & Cable Co.,Ltd. and 37104-3163-000 FL made in 3M
An average of 23.0N (the fewest 18.8N).
Quality Performance
Unit Characteristics
TEST
DESCRIPTION
REQUIREMENT TEST CONDITION RELATED STD.
Reference
Dielectric with-
standing voltage
No appearance of arcing
and break down.
Leak current : 1mA max
Impressed voltage is AC 1000V rms between
two adjacent contacts for 1 minute.
MIL-202F-301
Insulation
Resistance
1000Mmin
Impressed voltage is DC500V between two
adjacent contacts for 1minute.
MIL-202F-302
Mating characteristic
It depends on combination with the Mini-Clamp connector series 371XX series
TEST
DESCRIPTION
REQUIREMENT TEST CONDITION RELATED STD.
Reference
Insertion &
Withdrawal Force
(Initial)
Insertion2N/pin max.
Withdrawal0.5N/pin
min.
Tensile speed : 5mm/min. Spec. value is
estimated by one contact pin.
Retention Force of
Latch
58.8N min Tensile speed: 25mm/min.
Durability Electrical properties
shall be stable after test
Insertion & Withdrawel 300 times. (Except
Latch Mechanism)
Vibration Electrical properties
shall be stable after
test. Discontinuity
1sec. max
Tested during vibration test together (See
table 1)
MIL-202F-201
A
Shock Electrical properties
shall be stable after
test. Discontinuity
1sec. max
50G , 11 msec , 3 cycles, 3 directions
(X,Y,Z)
MIL-202F-213
B
Electrical Specifications
TEST
DESCRIPTION
REQUIREMENT TEST CONDITION RELATED STD.
Reference
Electrical
Continuity
Electrical properties shall
be state under test.
Discontinuity 1sec max
Tested during Vibration test together Refer TABLE-2
Contact Resistance The initial readings are in
milli-ohms. 20mmax
The low-signal level contact resistance shall be
tested with circuit current of 1mA and open
circuit voltage of 20 mV maximum. The
termination resistance includes bulk resistance
of contact, and resistance of solder joints of
connectors to circuit boards.