Installation Manual

Installation
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
April 24 2015 – Revision 1.0
Page 31 of 76
• Configure the dip switches according to the table on the circuit board
and your needs (see Figure 14).
•
•
•
Figure 13
• Adjust the sensitivity of vehicle detection by manipulating the top two
dip switches.
• Enable or disable a two second detection delay by manipulating the
third switch
• Choose presence or pulse detection by manipulating the fourth switch.
Figure 14
Vehicle Detector LED
There are two small LEDs on the vehicle detector that can be in one of three
states when powered and operating:
• Steady green—indicates that power is applied and no vehicle is
currently detected.